Using the printer | 2 |
|
This section describes how to perform basic tasks required to operate the
Datacard® RP90 Plus E printer and the Datacard® RL90 card laminator.
It describes how to:
Load supplies
•“Load cards” on page 8
•“Load ink ribbon” on page 9
•“Load retransfer film” on page 10
•“Load laminate” on page 11 Power on
•“Check the PC connection” on page 12
•“Optional laminator connection” on page 13
•“Power on the laminator” on page 14
•“Power on the printer” on page 15
Prepare to print cards
•“Initialize the ink ribbon” on page 16
•“Set the retransfer film type” on page 16
•“Initialize the retransfer film” on page 17
•“Initialize the patch or topcoat material (optional RL90 laminator only)” on page 17
Print cards
•“Print cards using ID software” on page 18
•“Print from a PC application” on page 19
Begin with the printer set up and the printer driver installed. This printer must be installed by Datacard authorized and trained personnel. If the printer is not set up, contact your service provider.
