Cleaning the laminator
Cleaning the laminator
Most card jams are caused by dirty rollers. Clean the laminator at the same time that you clean the printer. If you are using the laminator as a
Run a laminator cleaning card
Tips – Laminator cleaning card
•When the heat roller is at operating temperature, “HR is too hot” is displayed on the LCD display. Turn power OFF and allow unit to cool for approximately 30 minutes before starting the cleaning sequence.
•Use a cleaning card one time only. Using a dirty cleaning card can cause card jams.
1Press the MENU key on the laminator LCD panel until "Cleaning" is displayed.
2To clean the transport roller only:
a Press the ENTER key and "Without HR" is displayed. b Press the ENTER key and "Cleaning OK" is displayed. c Press the ENTER key and cleaning starts.
3To clean the transport roller and heat roller:
a Press RESET and then ENTER and "With HR" is displayed. b Press ENTER and "Film removed?" is displayed.
c Remove the laminator cartridge, remove patch or topcoat material, replace the empty cartridge into the laminator, and close the laminator door.
d Press the ENTER key and "Cleaning OK?" is displayed.
e Remove the protective paper from the cleaning card and press the ENTER key.
fSlide the cleaning card into the
card discharge slot. The card will be drawn into the laminator and will exit from the same slot when cleaning is complete.
4 Press the EXIT key twice to exit the cleaning menu.
5Reload and initialize the material.
RP90 Plus E and RL90 User Guide | 49 |
