Using the LCD menus
Using the Laminator LCD panel
Use the LCD panel to change laminator settings, or use the Laminator tab of the Status Monitor to change some settings from the PC.
LCD Display | Settings | Function |
|
|
|
Mode | Single | Default setting; laminates on one side only. |
| Pass | Passes card without laminating. |
|
|
|
Film | ||
| 0.6 mil | Use for patch film |
| overlay | Use with topcoat with no positioning markings. |
|
|
|
Film Position | Adjusts the patch transfer position. Default setting is 0; the | |
|
| patch moves to the right with a positive value and to the left |
|
| with a negative value. |
|
|
|
Temp | Temperature, default 170° | Press the RESET/K key to set temperature from 120° C to |
|
| 200° C in 5° increments. |
|
| Press the ENTER key to confirm selection. |
|
|
|
Speed | Lamination speed, default | Press ENTER and use the RESET/K key to set lamination |
| 5.5mm/sec | speed from 2mm/sec to 10mm/sec in 0.5mm/sec |
|
| increments. The value that can be set may be limited by |
|
| the temperature setting. |
|
| Press the ENTER key to confirm selection. |
|
|
|
Card Fan | Off, Low, Half, High, or | Press the RESET/K key to turn the card cooling fan Off |
| Full | (default), Low, Half, High, or Full. |
|
| Press the ENTER key to confirm selection. |
|
|
|
Cool Time | 0 (default), 5, 7, or 10 | Press the RESET/K key to select the amount of cooling |
| seconds | time before laminating starts. |
|
|
|
Power Save | Off, 10, 20, 30 (default), | Lowers the heater temperature if no lamination has |
| or 60 minutes | occurred in the set time period. Preheating automatically |
|
| returns when a card enters the laminator. |
|
| Using the default value of 30 minutes can reduce |
|
| discoloration of the laminator material. |
|
|
|
LCD contrast | 1 to 5 | Press the RESET/K key to set the LCD display contrast |
|
| from 1 to 5. The larger the number, the higher the contrast. |
|
|
|
Cleaning | Without HR | Cleans the transport roller only. |
|
|
|
| With HR | Cleans transport and heat rollers. Remove the laminate |
|
| cartridge to clean the heat roller. See “Cleaning the |
|
| laminator” on page 49 for more information. |
|
|
|
Online Setting |
| Displays settings sent from the PC when the RL90 is |
|
| connected through an RP90 Plus E printer to a PC. |
|
|
|
42 | RP90 Plus E and RL90 User Guide |
