Printer error recovery
Bend remedy laminator settings
When the laminated card warps concave, the printer bend remedy settings should be effective in correcting the problem. See “Bend remedy printer settings” on page 56 on the previous page.
If the laminated card warps convex, set the printer Bend Remedy> Temp Level to Off and set the laminator’s
Card Fan to one of five settings.
Set the printer Bend Remedy>Temp Level to Off when laminating cards that have been printed on both sides.
To set the laminator Card Fan:
1 Press the MENU key on the laminator LCD display until “Card Fan” is displayed.
2Press the ENTER key.
3Press the RESET/K key to select from five settings: Off, Low, Half, High, or Full. You may need to experiment with this setting to obtain satisfactory results.
4Press the ENTER key to confirm the setting.
RP90 Plus E and RL90 User Guide | 57 |
