Status Monitor
•The current state of the printer, such as ready. The icon changes with different states. See the table below.
Icon | Status | Icon Color | Meaning |
|
|
|
|
|
|
|
|
| No Printer is found. | Yellow | The printer power is not switched on. or the host PC and |
|
|
| printer are not connected properly by the USB cable. |
|
|
|
|
| Ready | Green | The printer is ready and able to start card printing. |
|
|
|
|
| Initializing | Yellow | The printer is initializing. After the printer is initialized, it |
|
|
| goes into Ready state. |
|
|
|
|
| Offline Mode | Yellow | The printer is in Setting mode or it is being cleaned. |
|
|
| When the process ends, it goes into Ready state. |
|
|
|
|
| Preheating | Yellow | The heat roller is heating. When it reaches the correct |
|
|
| temperature, the printer goes into Ready state. |
|
|
|
|
| Card Loading | Yellow | The printer is issuing cards. The operating status during |
| Card Transporting |
| card issuing is indicated. When the card is issued, the |
| MG Encoding |
| printer goes into Ready state. |
| Retransfer |
|
|
| Contact IC Encoding |
|
|
|
|
| |
| Encoding |
|
|
| Unloading |
|
|
| Printing |
|
|
|
|
|
|
| Power Saving | Yellow | The printer is in power save mode. To end Power |
|
|
| Saving, press the RESET button on the printer and then |
|
|
| press the ENTER button to initialize the printer. |
|
|
|
|
| Error | Red | See “Status monitor messages” on page 31. |
|
|
|
|
Printer Setting tab
The Printer Setting tab shows:
•Controls for viewing or changing print settings:
—Resin K Print Level, which sets the K resin ink print density.
—Level of UV Ink and Level of Special Ink 2 which are not supported.
—Resin K Print Mode which sets the K resin ink print quality. If Fine is selected, the print quality improves but the printing speed is slower.
—Cooling Time which sets the time in seconds to wait until the retransfer film
peels off from the card after retransfer. The default value is 0.
RP90 Plus E and RL90 User Guide | 27 |
