Datacard Group RL90, RP90 manual Menu Display

Using the LCD menus

Menu Display

Ink

Retransfer

Standby

Buzzer

Power Saving

Bend Remedy

Settings

Ink Type

YMCK: 0

YMCKPO: 2

YMCKK: 4

Black level

Black mode

SP - Ink1 Level

SP - Ink2 Level

Media type: 750 1000

Temp Level

Speed (front)

Speed (back)

MG Print (JIS)

Front Wait

Back Wait

ON or OFF

OFF or up to 60 minutes

Temp Level

Speed

Cooling time

Function

Displays the type of ink ribbon that is loaded in the printer. Datacard supports YMCK and YMCKK ink ribbons. (The printer detects the type of ink ribbon; it cannot be set.) See your dealer regarding support for YMCKPO ink ribbon.

Choose from seven gradations from -3 (lighter) to +5 (darker).

Choose Standard or Fine. Change to Fine if thin lines or small black text is blurred (printing speed is slower).

Use SP - Ink1 and Ink2 levels to set the darkness level of special inks that will be available in the future.

See SP -Ink1 Level above.

Datacard retransfer ribbon is available in 1000 frames per roll.

Set the retransfer roller temperature. Set from -3 (lower) to +2 (higher).

Set the retransfer speed for the front of the card. Set from -10 (slower) to +2 (faster). Initialize the retransfer film after making changes. See “Initialize the retransfer film” on page 17.

Set the retransfer speed for the back of the card. Set from -10 (slower) to +2 (faster). Initialize the retransfer film after making changes. See “Initialize the retransfer film” on page 17.

Select ON or OFF.

When printing both sides of a card and using an optional smart card (IC) unit, specifies whether to wait after the front side or the back side of the card.

Use to turn the electronic beep sound ON or OFF. The sound can indicate an error, when fewer than 20 cards remain in the card hopper, or to confirm a menu selection.

The printer enters power save mode after a specified period of inactivity. Choose from OFF or select from 5 to 60 minutes in 5 to15 minute increments. “Sleeping” appears on the LCD display. To cancel power save mode, press RESET and then the ENTER key. The printer uses one set of supplies.

Choose from -5 (lower) to 0 (higher) or OFF to set the bend remedy roller temperature. See “Bend remedy” on page 56 for more information.

Choose from -2 (slower) to +2 (faster) to set the bend remedy speed. See “Bend remedy” on page 56 for more information.

Set the cooling time from 0 (None) to 15 seconds.

RP90 Plus E and RL90 User Guide 37