Using the LCD menus
Menu Display
Ink
Retransfer
Standby
Buzzer
Power Saving
Bend Remedy
Settings
Ink Type
YMCK: 0
YMCKPO: 2
YMCKK: 4
Black level
Black mode
SP - Ink1 Level
SP - Ink2 Level
Media type: 750 1000
Temp Level
Speed (front)
Speed (back)
MG Print (JIS)
Front Wait
Back Wait
ON or OFF
OFF or up to 60 minutes
Temp Level
Speed
Cooling time
Function
Displays the type of ink ribbon that is loaded in the printer. Datacard supports YMCK and YMCKK ink ribbons. (The printer detects the type of ink ribbon; it cannot be set.) See your dealer regarding support for YMCKPO ink ribbon.
Choose from seven gradations from
Choose Standard or Fine. Change to Fine if thin lines or small black text is blurred (printing speed is slower).
Use SP - Ink1 and Ink2 levels to set the darkness level of special inks that will be available in the future.
See SP
Datacard retransfer ribbon is available in 1000 frames per roll.
Set the retransfer roller temperature. Set from
Set the retransfer speed for the front of the card. Set from
Set the retransfer speed for the back of the card. Set from
Select ON or OFF.
When printing both sides of a card and using an optional smart card (IC) unit, specifies whether to wait after the front side or the back side of the card.
Use to turn the electronic beep sound ON or OFF. The sound can indicate an error, when fewer than 20 cards remain in the card hopper, or to confirm a menu selection.
The printer enters power save mode after a specified period of inactivity. Choose from OFF or select from 5 to 60 minutes in 5 to15 minute increments. “Sleeping” appears on the LCD display. To cancel power save mode, press RESET and then the ENTER key. The printer uses one set of supplies.
Choose from
Choose from
Set the cooling time from 0 (None) to 15 seconds.
38 | RP90 Plus E and RL90 User Guide |