LCD Message | Possible Cause | Solution |
|
|
|
HR Cam | Heater Cam error. | Turn the power switch off, and then back on. Contact |
|
| your service provider if this does not correct the |
|
| condition. |
|
|
|
Heater Err | The heater temperature | Check that the voltage inlet switch, located on the |
| does not increase. | back of the laminator, is in the proper position for the |
|
| input voltage. Contact your service provider if this |
|
| does not correct the condition. |
|
|
|
HR Overheat | Heat roller temperature is | Turn the unit off and contact your service provider |
| too high. | before powering back on. |
|
|
|
Temp Sensor | The heat roller | Turn the unit off and contact your service provider |
| temperature sensor is not | before powering back on. |
| working. |
|
|
|
|
Memory Err | There is an internal | Turn the unit off and contact your service provider |
| memory error. | before powering back on. |
|
|
|
Set Temp Err | There is an error with the | Turn the unit off and contact your service provider |
| heat temperature setting. | before powering back on. |
|
|
|
R. Encoder Err | Rotary encoder error. | Turn the unit off and contact your service provider |
|
| before powering back on. |
|
|
|
Overheat | The temperature inside the | Turn the unit off and contact your service provider |
| unit is too high. | before powering back on. |
|
|
|
PRT. Communicate | Communication error with | Check that the laminator cable is connected securely |
| the printer. | to the printer. |
|
| Turn the printer and laminator off, and then back on to |
|
| recycle the power. |
|
|
|
Film Exchanged? | The patch or topcoat | Press the RESET/K and then the ENTER key to |
| material was changed | initialize the patch or topcoat material. |
| while the laminator was |
|
| turned off. |
|
|
|
|
66
