Datacard Group RL90, RP90 manual Laminator LCD messages

		Laminator error recovery
Laminator LCD messages
LCD Message	Possible Cause	Solution
Please Power OFF	To initialize this unit, the	Turn the laminator’s power switch off, and then back
	power must be switched	on to initialize the laminator.
	off once.
Please Reset	Displayed when Reset is	Press the RESET/K and then the ENTER key to
	necessary after changing	initialize the laminator.
	the settings.
Please check inside	The power was switched	Remove the laminator cartridge and check for a card
	off during lamination.	inside the machine. If there is a card in the machine,
		remove it.
		Press the RESET/K and then the ENTER key to
		initialize the laminator.
Card Jam (in)	There is a card jam in the	Check that the laminator is properly connected to the
	entrance area.	printer as described in “Optional laminator
		connection” on page 13.
		See “Card jam” on page 62 to clear the jam.
Card Jam (middle)	There is a card jam in the	The laminating temperature is too high or the speed is
	center of the card path.	too slow. Set the temperature or speed as described in
		“Using the Laminator LCD panel” on page 42.
		See “Card jam” on page 62 to clear the jam.
Card Jam (out)	There is a card jam in the	The laminating temperature is too high or the speed is
	card discharge area.	too slow. See “Card jam” on page 62 to clear the
		jam.
Film search	The laminator is searching	Check that the laminating film is correctly loaded as
	for laminate material.	described in “Load laminate” on page 11.
		Press the RESET/K and then the ENTER key to
		initialize the laminating material.
Film run out	The end of the roll mark	Replace the laminating material as described in “Load
	has been detected.	laminate” on page 11.
		Press the RESET/K and then the ENTER key to
		initialize the laminator.
No Cassette	The laminator cartridge is	Install the laminator cartridge as described in “Load
	not installed.	laminate” on page 11.
		Press the RESET/K and then the ENTER key to
		initialize the laminator.
Overcool	The area surrounding the	See “Operating environment” on page 72 for
	laminator is too cold.	location guidelines.
HR is too hot!	The heat roller is too hot	Turn the power switch off and allow the roller to cool
	for the cleaning operation.	before attempting to clean it. See “Cleaning the
		laminator” on page 49 to clean the heat roller.

RP90 Plus E and RL90 User Guide 65