Datacard Group RL90, RP90 manual Load laminate, Tips Handling patch, Or topcoat material

Load Supplies

Load laminate
Tips: Handling patch		1 Open the laminator door by
			pulling the top of the door
or topcoat material
			toward you.
	After powering on the
•		2	Press the laminator cartridge
	laminator, the patch or		eject button and remove the
	topcoat material must be		laminator cartridge carefully.
	initialized. Press the		The material must be tight
	laminator’s RESET/K and		when removing the cartridge.
	then the ENTER keys to	3	Place the roll of
	initialize the material.
			material and
•	The inside of the laminator		empty take-up
			spool side by side
	contains hot surfaces. Use		on a clean
	care when working in these		surface.
	areas.	4	Remove the label from the
•	Keep unused laminating		patch or topcoat material and
			use it to secure the free end of
	material in the original
			the material to the empty take-
	package.
			up spool, making sure the
•	Don't place material on a		edges are even.
		5	Load the new roll of material
	dusty or dirty surface — dirt
			on the cartridge:
	can affect card quality.
			a Put the full roll of material
•	During the laminating		on the supply spindle.
	process, do not turn the		b Put the empty take-up
	power switch off, open the		spool on the take-up
	laminator door, or unplug the		spindle.
	laminator.		c Align the material along
	See “Laminator material” on		the four metal guides as
•			shown on the cartridge
	page 68 for more information		label.
	about laminating material.		d Wind two or three
			rotations of film onto the
			take-up spool. Take up
			slack between the spools
			by turning the supply knob
			clockwise. If slack cannot
			be removed, check that
			the supply and take-up
			spools are firmly seated on
			the spindles.
		6 Replace the loaded laminator
			cartridge in the laminator until
			it clicks into position.
		7 Close the laminator door.
RP90 Plus E and RL90 User Guide			11