Dell 1950 owner manual System detected and corrected a No action is required

Table 1-8. System Messages (continued)

Message	Causes	Corrective Actions
General failure	The operating system is unable to carry	This message is usually followed by
	out the command.	specific information. Note the
		information, and take the appropriate
		action to resolve the problem.
Invalid NVRAM	System detected and corrected a	No action is required.
configuration, Resource	resource conflict.
Re-allocated
Keyboard Controller	Faulty keyboard controller; faulty	See "Getting Help" on page 125.
failure	system board
Manufacturing mode	System is in manufacturing mode.	Reboot to take the system out of
detected		manufacturing mode.
MEMBIST failure - The	Faulty memory module(s).	See "Troubleshooting System Memory"
following DIMM/rank has		on page 102.
been disabled by BIOS:
DIMM x Rank y
Memory address line	Faulty or improperly installed memory	See "Troubleshooting System Memory"
failure at address, read	modules.	on page 102.
value expecting value
Memory double word logic
failure at address, read
value expecting value
Memory odd/even logic
failure at address, read
value expecting value
Memory write/read failure
at address, read value
expecting value
Memory tests terminated by	POST memory test terminated by	Information only.
keystroke.	pressing the spacebar.
No boot device available	Faulty or missing optical drive	Use a CD or hard drive. If the problem
	subsystem, hard drive, or hard-drive	persists, see "Troubleshooting an Optical
	subsystem, or no boot disk in drive A.	Drive" on page 103 and "Troubleshooting
		a Hard Drive" on page 104. See "Using
		the System Setup Program" on page 31
		for information on setting the order of
		boot devices.

About Your System

27