3 Mechanical Installation
Before installing or removing a Solutions Module in any drive, ensure the AC supply has been disconnected for at least 10 minutes and refer to Chapter 1 Safety Information on page 5. If using a DC bus supply ensure this is fully discharged before working on any
WARNING drive or Solutions Module.
3.1General Installation
The installation of a Solutions Module is illustrated in Figure
Figure 3-1 Fitting a Solutions Module
1 |
2 |
The Solutions Module connector is located on the underside of the module (1). Push this into the Solutions Module slot located on the drive until it clicks into place (2). Note that some drives require a protective tab to be removed from the Solutions Module slot. For further information, refer to the appropriate drive manual.
10 | |
www.controltechniques.com | Issue Number: 2 |
