Emerson Process Management 2051 manual Rosemount, Reference Manual, Primary_Value_Range

Reference Manual

00809-0200-4101, Rev AA July 2008

Rosemount 2051

	Index
Parameter	Number	Description
PRIMARY_VALUE_RANGE	15	The high and low range limit values, the engineering unit code, and the number of
		digits to the right of the decimal point to be used to display the final value.
		Valid engineering units are the following:
		1130		= Pa
		1133		= kPa
		1137		= bar
		1138		= mbar
		1139		= torr
		1140		= atm
		1141		= psi
		1144		= g/cm2
		1145		= kg/cm2
		1148		= inH2O @ 68 °F
		1151		= mmH2O @ 68 °F
		1154		= ftH2O @ 68 °F
		1156		= inHg @ 0 °C
		1158		= mmHg @ 0 °C
PRIMARY_VALUE_TYPE	13	Type of measurement represented by the primary value.
		107 = Differential pressure
		108 = Gage pressure
		109 = Absolute pressure
SECONDARY_VALUE	29	The secondary value, related to the sensor.
SECONDARY_VALUE_UNIT	30	Engineering units to be used with SECONDARY_VALUE.
		1001 °C
		1002 °F
SENSOR_CAL_DATE	25	The last date on which the calibration was performed.This is intended to reflect the
		calibration of that part of the sensor that is usually wetted by the process.
SENSOR_CAL_LOC	24	The last location of the sensor calibration. This describes the physical location at
		which the calibration was performed.
SENSOR_CAL_METHOD	23	The last method used to calibrate the device.
		103 = factory trim standard
		104 = user trim standard
SENSOR_CAL_TYPE	35	The type of last sensor calibration.
		0	= Differential pressure
		1	= Gage pressures
		2	= Absolute pressure
		252 = Unknown
SENSOR_CAL_WHO	26	The name of the person responsible for the last sensor calibration.
SENSOR_FILL_FLUID	28	Type of fill fluid used in sensor.
		0	= Undefined
		1	= Silicone
		2	= Inert
		3	= Undefined
		7	- Neobee
		251 = "None"
		252 = "Unknown"
		253 = "Special"
SENSOR_ISOLATOR_MTL	27	Defines the construction material for the isolating diaphragms.
		2	= 316 Stainless Steel
		3	= Hastelloy C™
		4	= Monel
		5	= Tantalum
		253 = "Special"
SENSOR_RANGE	21	The high and low range limit values, the engineering units code, and the number of
		digits to the right of the decimal point for the sensor.
SENSOR_SN	22	Serial number of the sensor.

C-3