Emerson Process Management 2051 manual Rosemount, Reference Manual, Rem_Seal_Fill

Reference Manual

00809-0200-4101, Rev AA July 2008

Rosemount 2051

	Index
Parameter	Number	Description
self_test	59	Instructs resource block to perform self-test. Tests are device specific.
distributor	42	Reserved for use as distributor ID. No Foundation enumerations defined at this time.
REM_SEAL_FILL	73	Type of fill fluid used in the remote seals.
		2	= Silicone
		3	= Syltherm 800
		4	= Inert (Halocarbon)
		5	= Glycerin and Water
		6	= Propylene Glycol and Water
		7	= Neobee M–20
		251 = None
		252 = "Unknown"
		253 = "Special"
REM_SEAL_ISO_MAT	70	Type of material of the remote seal isolators. See remote seal number codes.
		2	= 316L Stainless Steel
		3	= Hastelloy C–276
		5	= Tantalum
		9	= Co–Cr–Ni
		251 = None
		252 = "Unknown"
		253 = "Special"
REM_SEAL_NUM	71	Number of remote seals.
		1	= One seal
		2	= Two seals
		251 = None
		252 = "Unknown"
		253 = "Special"
REM_SEAL_TYPE	66	Type of remote seals.
		0	= Undefined
		1	= Reserved
		2	= CTW
		3	= EFW (Expanded Flange Seal)
		4	= PFW (Pancake)
		5	= RFW (Flanged Remote)
		6	= RTW (Threaded Remote)
		7	= SCW
		8	= SSW
		9	= High Temperature
		10 = FFW (Flanged Flush Surface)
		11 = UCW
		12 = TSW
		251 = None
		252 = "Unknown"
		253 = "Special"
RESTART	16	Allows a manual restart to be initiated. Several degrees of restart are possible. They are
		the following:
		1	Run – nominal state when not restarting
		2	Restart resource – not used
		3	Restart with defaults – set parameters to default values. See
		START_WITH_DEFAULTS below for which parameters are set.
		4	Restart processor – does a warm start of CPU.
RS_STATE	07	State of the function block application state machine.
save_config_blocks	62	Number of EEPROM blocks that have been modified since last burn. This value will count
		down to zero when the configuration is saved.
save_config_now	61	Controls saving of configuration.
security_IO	65	Status of security jumper/switch.
SHED_RCAS	26	Time duration at which to give up on computer writes to function block RCas locations.
		Shed from RCas shall never happen when SHED_ROUT = 0
SHED_ROUT	27	Time duration at which to give up on computer writes to function block ROut locations.
		Shed from ROut shall never happen when SHED_ROUT = 0

C-9