98 Maintenance

CHANGING FORMS COMPRESSOR

The forms compressor is located between the platen and the printhead carriage, as shown in the illustration. Its purpose is to hold the paper flat against the platen during printing.

Forms compressor replacement is required only if it is broken, bent, or worn.

To change a forms compressor, proceed as follows:

1.Turn off printer and unplug the power cord.

2.Open the operator access door.

3.Note the setting of the printhead gap adjustment lever and then remove paper and ribbon cartridge. (If necessary, see "To remove a ribbon cartridge," Page 100.)

4.Make sure the printhead gap adjustment lever is toward the front of the printer as far as possible.

Page 118
Image 118
Epson 4100 manual Changing Forms Compressor