286 DEC LA210 Control Commands
ASCII: | ESC | [ | (n) | t |
Control: | CTRL [ | [ | (n) | t |
Decimal: | 27 | 91 | (n) | 116 |
Hexadecimal: | 1B | 5B | (n) | 74 |
Sets the length of the form to n lines, not physical units. Changing the vertical pitch (lines per in.) alters the physical form length.
The maximum value of n is determined by the current vertical lines per inch setting, as follows:
•6 lines per in.: n = 132, max.
•8 lines per in.: n = 176, max.
Changing form length clears the vertical margins and defines the current line as Line 1.
If the value of n is 0, the printer enters No Form mode. Refer to the following command.
ESC [ Ø t |
|
|
| No Form Mode |
|
|
|
|
|
ASCII: | ESC | [ | Ø | t |
Control: | CTRL [ | [ | Ø | t |
Decimal: | 27 | 91 | 48 | 116 |
Hexadecimal: | 1B | 5B | 30 | 74 |
Causes the printer to enter No Form mode. In this mode, there are no vertical margins or form length. Printing is continuous and line spacing is determined by the current pitch.
This command overrides the form length setting selected from the configuration menu. No Form mode remains in effect until the printer power is turned off, or a new, nonzero form length is set with ESC [ (n) t.
