Epson 4100 manual Esc S, Esc T

			Operator’s Guide 215
ESC S			Set Subscript/Superscript
ASCII:	ESC	S	(n)
Control:	CTRL [	S	(n)
Decimal:	27	83	(n)
Hexadecimal:	1B	53	(n)

Prints characters following this control command as subscript or superscript characters. n specifies which is selected as follows:

•n = 1 or 49: Select subscript

•n = 0 or 48: Select superscript

Subscript or superscript characters are printed at normal height. ESC S remains in effect until ESC T is received. Multiple ESC S (n) commands may be sent prior to an ESC T.

Note: This function works only if Sub/Superscript is enabled from the configuration menu .

ESC T		Cancel Subscript/Superscript
ASCII:	ESC	T
Control:	CTRL [	T
Decimal:	27	84
Hexadecimal:	1B	54
Cancels subscript/superscript set by ESC S.

ESC 4		Set Italics
ASCII:	ESC	4
Control:	CTRL [	4
Decimal:	27	52
Hexadecimal:	1B	34

Allows most upright draft quality or NLQ style (condensed, bold, enlarged, single/double strike) to be printed in italics.

Epson italic characters reside in the upper half of the Epson character sets. ESC 4 causes this upper half to be mapped to the lower bytes.

ESC 5 Cancel Italics