Epson 4100 manual ESC n Select G0

272 DEC LA210 Control Commands

The control commands to select character maps G0 through G3 are:

•	ESC ( (n)	Select G0	ESC ) (n)	Select G1
•	ESC * (n)	Select G2	ESC + (n)	Select G3

n specifies the character map as follows:

	n=Character Map		n=Character Map		n=Character Map
A	United Kingdom	Z	Spain	5	Finland
B	United States	h	Hebrew	6	Norway/Denmark
K	Germany	<	Multilingual	7	Sweden
R	France	0	VT100 Line Draw	9	Canada
Y	Italy

With the exception of Multilingual and VT100 Line Draw, the available character maps are national-use character maps. See Appendix D for charts of these character maps.

Additional information for each command is provided on the following pages.

ESC ( (n)			Select G0
ASCII:	ESC	(	(n)
Control:	CTRL [	(	(n)
Decimal:	27	40	(n)
Hexadecimal:	1B	28	(n)

Assigns a character map to G0. n specifies one of the character maps listed previously.

This control command does not change the character set currently in use. The selection takes effect when G0 is mapped into the lower data bytes using control code SI. G0 cannot be mapped into the upper data bytes.