Using the Serial Interface If you use a serial interface, you need to confirm that the pr int er and the
computer are using the same serial settings. If the serial settings do no t
match, you must change the appropriate settings. The settings can be
changed either at the printer or computer.
The default serial settings for the serial interface are listed below. To
change the serial settings, use the Remote Control Panel utility. Fo r
information about your computer’s serial settings, see your c om p ut er
manual.
Serial type: RS-232C
Word length: 8
Baud rate: 9600
Parity: NONE
Stop bit: 1
XON/XOFF: ON
DSR: OFF
You also need to change your computer’s port setting if it is not already
set to the serial port. The following procedure describes how to change
the port setting in Windows. To change the setting using non-Windows
software, see your software manual.
For Windows 3.1, Windows 3.11 for Workgroups, andWindows NT 3.511. In the Main window, double-click the Contro l Panel icon.
2. Double-click the Printers icon.
3. In the Printers dialog box that appears, click the Connect button.
4. Select a COM (serial) port.
5. Click the OK button.
6. Close the Printers dialog box.
For Windows 95 and Windows NT 4.01. Click the Start button, point to Settings, and then click Printers.
2. Right-click the EPSON EPL-5700 icon, and click Properties in the menu
that appears. Be sure to right-click your prin te r.
R
Ktwk Rev.C
A5 size Appendix A
97/12/26 pass 0