The printer doesn’t pr int and the On Line light is off.
Press On Line once to put the printer on line (the On Line light
comes on).
The On Line light is on but nothing prints
Your computer may not be properly connected to the printer.
Perform the procedure described in “Connecting the printer to
the computer” in the Getting Ready! booklet.
The interface cable may not be plugged in securely. Check both
ends of the cable between the printer and the computer. Be sure
to secure the connector using the wire retaining clips.
Make sure you use a double-shielded, twisted-pair interface
cable no longer than six feet in length.
If you are using a serial interface, set the parity, baud rate,
number of data bits, and number of stop bits to match the
computer.
The developer cartridge may be empty. Replace the cartridge as
described on page 6-28.
The Remote Control Panel utility does not function as expected.
Your settings may have been changed by your software
program, which overrides the Remote Control Panel utility.
Initialize the printer as described later in this chapter.
LKtwk rev.C
Reference Guide
A5 size Chapter 6
’97/12/24 DR, pass 0
6-14 Troubleshooting and Maintenance