Parallel Bi-D
Specifies the what mode you use, Nibble, ECP, or Off.
Parallel Buffer Size
Determines the amount of memory to be used for receiving and
printing data. If set to Maximum, more memory is allocated for
receiving data. If set to Minimum, more memory is allocated
for printing data. The factory defa ult setting is Normal.
Serial Word Length
You can select an 8-bit or 7-bit word length. See your computer
manual and software documentaio n for the proper setting. The
factory setting is 8-bit.
Serial Baud Rate
Use this option to set the data transfer rate (baud) for the serial
interface. The baud rate is measured in bits per second (bps).
See your computer manual and software documentatio n for the
proper setting.
Serial Parity
When this option is set to None, parity checking is disabled.
The parity bit, if used, provides a basic form of error detection.
See your computer manual and software documentatio n for the
proper setting.
Serial Stop Bit
Use this option to set the number of stop bits for each character
of information sent to the printer. Stop bits signal the end of a
character.
Serial DTR
Use DTR (Data Terminal Ready) to turn the printer’s DTR
communications protocol on or off. You can use DTR protocol
in combination withe the Xon/Xoff option setting.
LKtwk Rev.B
Reference Guide
A5 size Chapter 5
’97/12/11 DR, pass 0
5-24 Remote Control Panel Utility