Auto Continue
Permits the printer to automatically recover from a Print
Overrun, Mem Overflow, or Paper Set error. The printer
continues printing within a few seconds after one of these
problems occurs.
When Auto Continue is off, you must press Continue to
resume printing. In most cases, leave Auto Continue off so you
can tell when an error occurs and make the necessary
corrections. You might want to set Auto Continue on when
printing long jobs or when you are away from the printer for
long periods.
Toner Save
Turns the Toner Save mode on. When turned on, the printer
saves toner by substituting a gray shade for the black inside of
characters. The characters are outlined in full black on the right
and lower edges.
Image Optimum (LaserJet4 only)
Reduces the amount of graphics data when the data reaches the
memory limit, allowing complex documents to be printed.
When this mode is on, graphics quality is reduced. The options
are Off, On, and Auto. On and Auto are the same.
Paper Type
Allows you to use various types of paper. Thin is useful for the
regular size plain paper under 75g/m2. Thick is useful for
irregular size plain paper over 75g/m2 and envelopes that are
less than 257mm wide. Transparency is useful for
transparencies. Always use Normal unless print quality
problems occur.
Interface
Specifies whether the printer can receive data through all the
interfaces available or only through the one selected.
LKtwk Rev.B
Reference Guide
A5 size Chapter 5
’97/12/11 DR, pass 0
5-14 Remote Control Panel Utility