Top Offset
Allows you to adjust the vertical printing position on the page.
The setting is in millimeters. You can move the printing
position by approximately 0.5 mm increments from the top
edge (the parameters are from -9 to 99).
Left Offset
Allows you to adjus t the horizontal pr inting position on the
page. The setting is in millimeters. You can move the printing
position in approximately 0.5 mm increments from the left
edge (the parameters are from -9 to 99).
Standby
Sets the Standby mode to Enable or Disable. When Standby is
enabled, the printer goes into a sleep mode if it is not used for
30 minutes. The printer begins warming up as soon as you send
data; it warms up and is ready to print in about 60 seconds.
When Standby is disabled, the printer stays warmed up and
ready to print all the time.
Timeout
Sets the length of time the printer waits before looking for the
next print job. If the printer is online and receives no new data
for the number of seconds specified, the printer automatically
switches to the next channel that receives data.
Paper Size Ignore
Selects whether a paper size error is ignored when it occurs.
Turning this item on causes the printer to print even if the
image size exceeds the printable area for the specified size of
paper. This may cause smudges, due to toner that is not
transferred onto the paper properly. When this item is off, the
printer stops printing if a paper size error occurs.
Country (ESCP2, FX only)
Selects the international character set.
LKtwk Rev.B
Reference Guide
A5 size Chapter 5
’97/12/11 DR, pass 0
5-22 Remote Control Panel Utility