Fujitsu DL3800 manual Changing Print Position Adjustment Options

USING SETUP MODE

CHANGING PRINT POSITION ADJUSTMENT OPTIONS

6.Do either of the following:

•Select another function, or

•Exit setup mode, saving your changes.

For details on other functions, see the other sections in this chapter. To exit setup mode and save your changes, make sure that the red cursor is positioned under SAVE/END, then press the FONT button or the MENU button.

When you print using ruled paper, you often want to adjust the print position so that the print sits properly on the ruled lines. The ADJUST function allows you to:

•Set top-of-form position

•Fine-tune top-of-form position

•Fine-tune left print start column (left margin)

•Adjust for accumlative line spacing error in a page

The first three items are provided separately for cut single sheets and continuous forms. The last item is available for single sheets only.

The top edge of your paper is the physical top of the page. The logical top of the page, as “understood” by the printer when loading paper, is called the top-of-form. Printing starts at this position. Note that printing actually starts at the position obtained by adding the following:

•Top-of-form, default = 1 inch (25.4 mm)

•Top margin specified by your software

•Printer TOP-MRG (top margin setting), default = 1 line

Table 5.5 describes the ADJUT items and options. Items are listed in the order they are printed. The procedure for changing top-of-form is described after Table 5.5.

5-34 User's Manual