Fujitsu DL3800 manual Cutload, Button, Loadtim, Decode, Direct

USING SETUP MODE

Table 5.6 CONFIG Items and Options (Cont.)

NOTE: Underlined options are the factory defaults.

CONFIG Items	Options	Description
<TEAR-EN>		In some application programs, data
(continued)		transfer may stop temporarily due
		to internal processing. This setting
		can avoid an undesired tearoff feed
		by waiting for up to six seconds
		each time data transfer stops.
<CUTLOAD>		Single sheet autoloading.
	AUTO	Single sheet paper is automatically
		loaded a certain time after you set
		the paper.
	BUTTON	Single sheet paper can be loaded by
		pressing the LOAD button.

The following <LOADTIM> item is printed when

CUTLOAD:AUTO is specified for the <CUTLOAD> item.

<LOADTIM>		Autoload start time.
	0.5, 1.0,	Autoloading starts when this
	1.5, 2.0	amount of time passes after you set
	2.5, 3.0SEC	single sheet paper.
<DECODE>		Command decode timing.
	DIRECT	The printer decodes certain com-
		mands immediately after receiving
		data.
		Example:
		ESC SUB I, ESC CR P (DPL24C+)
		ESC Q # (IBM XL24E)
	QUEUED	The printer decodes commands after
		storing all data (including com-
		mands) in the input buffer. This
		speeds data reception because the
		printer does not require decoding
		time during data reception.

5-40 User's Manual