Fujitsu DL3800 manual Paper Thickness Lever Settings, Using Single Sheets

PAPER HANDLING

Table 3.2 Paper Thickness Lever Settings

Number of Copies	Setting *2
(Including the Original) *1
1 copy	1
2 copies	2
3 copies	3
4 copies	4
5 copies	5
Ribbon replacement	D

*1 For carbon-interleaved paper, the carbon counts as one copy. *2 Vary the setting up or down (including A to D) to optimize

	printing. Select D when replacing a ribbon or clearing a paper
	jam. For labels and envelopes, use trial-and-error to determine
	a satisfactory setting.
	NOTE
	If printing is messy, the ribbon misfeeds, or the paper jams,
	move the lever one setting higher.
USING SINGLE SHEETS	This section describes how to load paper in the cut sheet stand or cut
	sheet feeder. The cut sheet stand allows paper to be loaded manually,
	one sheet at a time. A cut sheet feeder allows paper to be loaded
	automatically from a stack.

Paper Handling

Loading a Single Sheet of Paper

To load a sheet of paper into the cut sheet stand:

1.Make sure that the printer is turned on. Check that rear-fed continuous forms are retracted to the park position. (For details, see the section Unloading Continuous Forms later in this chapter.)

User's Manual 3-5