Fujitsu DL3800 manual Testing the Printer, Offline, Loading a sheet of paper

SETTING UP

TESTING THE PRINTER	At this point, load paper and run the printer self-test. The self-test
(OFFLINE)	checks printer performance and print quality before you connect the
	printer to the computer. Use either single sheets or continuous forms
	(see Chapter 3). This section describes the self-test procedure using
	single sheets.
	Loading Paper for the Self-Test
	To print the self-test, use paper wider than 215.9 mm (8.5 inches) and
	set the left paper guide all the way to the right to avoid clipping the test
	pattern. Standard letter or A4 size paper can be used lengthwise
	(portrait mode).
	Before loading paper, make sure that the printer is on. Then, proceed
	as follows:
	1. Make sure that the paper thickness lever (located on the top
	right of the printer) is at position 1. Make sure that the paper
	select lever (located on the top left of the printer) is set to the
	front, as shown below.

Loading a sheet of paper

Setting Up

User's Manual 2-13