Fujitsu DL3800 manual See the section Changing Hardware, See the section Changing Print Position

USING SETUP MODE

Table 5.2 Required Options (Cont.)

Function	Item	Option
HARDWRE	FORMAT	If you have a serial interface, the serial
	BAUD-RT	interface options selected on the printer
	PROTOCL	must be the same as the settings you
	DSR	selected using your software or your
	DUPLEX	computer operating system. If the settings
		are not the same, the printer will not
		print or will print garbage.
		See the section Changing Hardware
		Options later in this chapter.
ADJUST	None	If you are not using software to specify
		the top margin of the page, use the
		printer’s default top-of-form setting,
		1 inch (25.4 mm) from the top of the
		paper. If you are using software to
		specify the top margin of the page,
		change the default setting to 1/6 inch
		(4.2 mm).
		See the section Changing Print Position
		Adjustment Options later in this
		chapter.
CONFIG	None	If you are using paper that is dark-
		colored or preprinted with dark colors,
		you may need to disable the AREA
		OVER detection function.
		See the section Changing Configuration
		Options later in this chapter.

Setup Mode

User's Manual 5-13