Fujitsu DL3800 manual Printing a List, Selected Options, Select the List function

USING SETUP MODE

PRINTING A LIST OF	The LIST function prints a list of all the printer’s currently selected
SELECTED OPTIONS	options. This function is useful for checking the printer settings when
	you first enter setup mode or just before you exit. To print a list of
	options, load continuous forms paper and then proceed as follows:
	1. Enter setup mode.
	Press the FONT button and the MENU button simultaneously
	until the printer beeps. Wait for the printer to stop printing
	and check that the following <<FUNCTION>> menu is
	printed:
<<FUNCTION>>
SAVE&END MENU1	MENU2 HARDWRE ADJUST CONFIG DEFAULT LIST SELF-TST HEX-DUMP
V-ALMNT
	2. Select the LIST function.
	Repeatedly press the LOCK button to position the red cursor
	under LIST. Next press the FONT button or the MENU button
	to select the LIST function. The printer starts to print a list of
	the currently selected options. The preselected factory
	settings, also called factory defaults, are shown on the opposite
	page.
	When the printer finishes printing the list of options, it reprints
	the <<FUNCTION>> menu.
	NOTE
	To remove the printout, turn the platen knob until the paper
	can be torn off at the perforation. In setup mode, you cannot
	use the printer tear-off feature (TEAR OFF button).
	3. Do either of the following:
	• Select another function, or
	• Exit setup mode, saving any changes you made.
	For details about other functions, see the other sections in this
	chapter. To exit setup mode and save your changes, make sure
	that the red cursor is positioned beneath SAVE & END, then
	press the FONT button or the MENU button.

5-10 User's Manual