Chapter 5 Configuration Menu
> 5.4 Host Interface Management
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
388 Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
5Click the [OK] button.
Returns to the [Allocate Host-Affinity Group (Initial)] screen.
End of procedure
5.4.6 Set LUN Mapping
On this screen, add/change/delete mapping information for the Logical Unit Number (LUN) rec-
ognized by hosts, and the Logical Volume number used in the ETERNUS DX400/DX8000 series,
without stopping operations. Relying on the mapping between the two types of numbers, hosts
can access the Logical Volumes in the ETERNUS DX400/DX8000 series.
Set LUN Mapping only when hosts and the ETERNUS DX400/DX8000 series are connected via
FC-CA or iSCSI-CA.
Make sure to stop host access to th e F C -C A P or t o r iS CS I- CA Po rt
when its LUN Mapping information is changed/deleted during operation.
When adding a new LUN Mapping, it is not necessary to stop host
access.
When copying LUN Mapping information to an active FC-CA or iSCSI-
CA, make sure to stop host access to the copy destination FC-CA or
iSCSI-CA port. When copying LUN Mapping information to a newly
added FC-CA or iSCSI-CA, it is not necessary to stop host access.
[Set LUN Mapping] is available when the [Affinity Mode] of the target
FC-CA Port or iSCSI-CA Port is [OFF (Disabled)].
Mapping to a "Work Volume" during RAID Migration is not allowed.
The operating status (Work Volume information) of Migration can be
checked by the [Progress of RAID Migration] function. "Work Volume" is
a temporary volume created for Migration operation.
Mapping to a Snap Data Pool Volume is not allowed.