Appendix A Screen Details
> A.18 Set CA Parameters
ETERNUS DX400/DX8000 series ETERNUSmgr User Guide Settings/Maintenance
748 Copyright 2010 FUJITSU LIMITED
P2X0-0760-02ENZ0
Port Mode
Select the desired port mode for the FCLINK Port by clicking the radio button.
-CU: (Default)
Port Mode for Mainframe host connections.
-CH:
Unsupported Port Mode (cannot be selected).
A.18.6 Set CA Parameters (iSCSI-CA Detailed Settings) Screen
Set the detailed information of the iSCSI-CA Port selected on the [Set CA Parameters (Initial)]
screen. The installation location of the iSCSI-CA Port is displayed on the screen as [CM#x CA#y
Port#z].
When it is necessary to convert a Host Response from the ETERNUS DX400/DX8000 series to
the host, the Host Response must be assigned to each iSCSI Host information item or each
iSCSI-CA Port. A target to which a Host Response is assigned varies depending on [ON/OFF] of
the Host Affinity function. Check the [Affinity Mode] of the iSCSI-CA Port.
When the Host-Affinity function is [ON (Enabled)]
Set Host Response for each iSCSI Host information using the [Set iSCSI Host] function.
When the Host-Affinity function is [OFF (Disabled)]
Set Host Response for each iSCSI-CA Port using this function. For details, refer to the
[Affinity Mode] description in the following table.
When Resource Domains are registered in the ETERNUS DX400/DX8000 series, the Host
Responses that can be set differ depending on the current user account.
When logged on using a Total Administrator account, all the Host Responses that are
assigned to Resource Domains can be set.
When logged on using a Resource Domain Administrator account, only the Host Responses
that are assigned to the relevant Resource Domain, and only the Host Responses that are
assigned to the Shared Resource can be set.
If a Host Response is deleted using the [Set Host Response] function, the
Host Response of each iSCSI-CA Port associated with the de l e te d H o s t
Response is changed to the [Host Response No.: Default].
If appropriate Host Responses are not registered in the ETERNUS DX400/
DX8000 series, register Host Responses using the [Set Host Response]
function.