
Starting up and operation
5.3Switching the server on and off
VCAUTION!
It nothing appears on the screen but flickering stripes after switching on the server, switch the server off immediately (see chapter "Troubleshooting and tips" on page 85).
The On/Off button does not disconnect the server from the mains voltage. To completely disconnect it from the mains voltage, remove the power plug(s) from the socket(s).
Switching the server on
The
–Starting up for the first time:
ÊPress the On/Off button (see figure 15 on page 68).
ÊInsert ServerView Suite DVD 1 in the DVD drive.
ÊFollow the
–System already installed:
ÊPress the On/Off button.
The server is switched on, performs a system test and boots the operating system.
IDepending on the configurations, the boot process may be prolonged and the screen may remain dark for a while.
Switching the server off
ÊShut down the operating system properly.
The server is switched off automatically and goes into standby mode. The
TX200 S6 | Operating Manual | 77 |