Fujitsu TX200 S6 manual Installing/removing the rack model, Rack system requirements

Hardware installation

4.3Installing/removing the rack model

VCAUTION!

●Please observe the safety information and notes on rack mounting in chapter "Important information" on page 31.

●At least two people are needed to install / remove the server in the rack. (For the Japanese market, please refer to " 安全上の注意および その他の重要情報 ".)

●The rack may tip over if more than one unit is removed at the same time.

●The server may not occupy the top height units of the rack (38HU/42HU PRIMECENTER Rack, DataCenter Rack, 19-inch standard rack (for the Japanese market)),

as otherwise boards cannot be replaced even with the plug-in module fully extended.

4.3.1Rack system requirements

The rack systems from Fujitsu PRIMECENTER Rack, DataCenter Rack and 19-inch standard rack (for the Japanese market) support the installation of PRIMERGY servers. Installation in most current rack systems from other manufacturers (3rd party racks) is also supported.

To accommodate the ventilation concept and ensure proper ventilation, any unused areas in the rack must be sealed using dummy covers.

The power is supplied via the multiple socket outlets fitted in the rack.

Fujitsu rack systems

The main features of PRIMECENTER Rack, DataCenter Rack and 19-inch standard rack (for the Japanese market) are as follows:

–support systems that can be mounted without tools

–support systems having a linear alignment feature to ensure that they can be adjusted to different rack depths

PRIMECENTER Rack and DataCenter Rack provide an enhanced cable management in the lateral rack area.

TX200 S6 Operating Manual 49