Hardware installation
4.2Setting up the floorstand model
IIf you are not installing a PRIMERGY TX200 S6 floorstand model, skip this section and continue reading at section "Installing/removing the rack model" on page 49.
VCAUTION!
Follow the safety instructions in chapter "Important information" on page 31.
ÊTransport the server to the place where you want to set it up.
ÊUnpack the server (see section "Unpacking the server" on page 46).
ÊSet up the server.
Note that for safety reasons (danger of tipping) the
VCAUTION!
–The device must be protected from direct sunlight.
–The essential minimum clearance for servicing must be maintained (see "Maintenance area for the floorstand model" on page 27).
–Access to the rear of the server must be assured so that other devices (e.g. memory subsystems) can be connected.
–A clearance of at least 200 mm must be maintained in front of and behind the system to ensure proper ventilation.
–The mains plug must be accessible easily and safely.
ÊWire the server. Read the information in section "Connecting devices to the server" on page 59 and section "Notes on connecting/disconnecting cables" on page 63.
ÊConnect the system to the mains (see section "Connecting the server to the mains" on page 60).
TX200 S6 | Operating Manual | 47 |
