Furuno 1753C, 1742, 1733C, 1752, 1723C, 1762C, 1732, 1722C, 1763C Entering a route with the cursor

3.PLOTTER OPERATION

5.If desired you can change the route name shown and/or add a comment. A route name may consist of six characters; comment, 13 characters.

6.Press the LOCAL LIST or ALPHA LIST soft key to open the waypoint list.

7.Use the cursor pad to select a waypoint, and press the ADD WPT soft key to add it to the route.

8.Repeat step 7 to complete the route.

Note: To clear a waypoint, press the ERASE LST WP soft key. Each pressing of this key deletes the last waypoint entered.

9.Press the SAVE soft key to register the route.

10.Press the [MENU] key to close the menu.

Entering a route with the cursor

This method allows you to construct a route directly on the plotter display, using existing waypoints or new locations. Any new location will be saved as a waypoint, under the youngest empty waypoint number.

1.Follow step 1-5 in “Entering a route from the route list” on the previous page.

2.Press the PLOT soft key to show the plotter display.

3.Operate the cursor pad to place the cursor on an existing waypoint (ADD WPT soft key appears) or new location (ADD NEW WPT soft key appears).

4.Press the ADD WPT soft key (or ADD NEW WPT soft key).

5.Repeat steps 3 and 4 to complete the route.

6.Push the [ENTER] knob to register the route.

7.Press the [MENU] key to close the menu.

3-38