3. PLOTTER OPERATION

Selecting an external waypoint

You can select a waypoint (or route) entered at an external plotter connected with NMEA cable. This function requires RMB sentence.

1.Press the [MENU] key, PLOTTER SETUP soft key to show the PLOTTER SETUP menu.

2.Use the trackball to select QP.

3.Press the ENTER soft key or [ENTER] key to show the QP window.

QP°

§EXT WPT (RMB) INTERNAL

QP window

4.Select EXT WPT (RMB).

5.On a connected external plotter, set a waypoint (or route) as the destination. Selected waypoint (route) appears on the NavNet plotter screen. (on radar screen, a lollipop appears to show the waypoint.)

3.10.3Navigating to ports, port services (NavCharts™/C-MAP)

Some NavChartsand C-MAP card have a port service list which shows services available at ports or harbors. (See page 3-13.) You can use the list to set destination as follows:

1.Select “35 PTS/PORT SVC” following the procedure in “Selecting quick point entry method” on page 3-45.

2.Press the GOTO soft key. Then, soft key titles change as in the figure below.

+ 40° 45.971'N

FROM

0.26 nm

GOTO

13° 57.462'E

OS

180.2° M

 

 

 

 

 

16.0nm

PUNTA CORNACCHIA

ACCO AMENO

QUICK

ROUTE

NEAR

SRVC

PORT

ISCHIA

PORTO

CASAMICCIOLA

I. ISCHIA

CANCEL

GOTO

Plotter display

3.Press the PORT or NEAR SRVC soft key depending on objective. PORT shows a list of ports in your area. NEAR SRVC displays the port service list.

3-47

Page 131
Image 131
Furuno 1762, 1753C, 1742, 1752 Navigating to ports, port services NavCharts/C-MAP, Selecting an external waypoint, QP window