1. OPERATIONAL OVERVIEW

1.3Turning the Unit On/Off

Press the [POWER/BRILL] key to turn the unit on. A beep sounds and the equipment proceeds in the sequence shown below, displaying the product information screen, startup test results and the chart usage disclaimer, in that order. The startup test checks the ROM, RAM, internal battery and backup data for proper operation, displaying the results for each as OK or NG (No Good). If NG appears, an appropriate message appears on the screen. For any NG, try to press any key to go to the chart disclaimer screen, then perform the diagnostic test referring to the paragraph “7.5 Diagnostics.”

Chart List

Host Name

RADAR PLOTTER

STATION NAME: RADAR

FURUNO ELECTRIC CO., LTD. CHARTS AVAILABLE FLYBRDG = ANB01004

RADAR = ANB01003

Product information

STARTUP TEST

ROM

OK

 

 

RAM

OK

 

 

BACKUP DATA

OK

 

 

INTERNAL BATTERY

OK

Startup test

** = Program version no.

(Two program version numbers. One for NAVIO and one for C-MAP.)

NO NATIONAL HYDROGRAPHIC OFFICE HAS VERIFIED THE INFORMATION IN THIS COASTLINE DATA CARD AND NONE ACCEPT LIABILITY FOR THE ACCURACY OF REPRODUCTION OR ANY MODIFICATIONS MADE THEREAFTER. THIS PRODUCT WITH THIS COASTLINE DATA CARD DOES NOT REPLACE THE REQUIREMENT TO USE THE APPROPRIATE PRODUCTS FOR NAVIGATION ACCORDING TO NATIONAL AND INTERNATIONAL REGULATIONS.

PROGRAM No. 03591730**

Chart disclaimer

The magnetron in the antenna unit takes about one minutes and thirty seconds to warm up before the radar can be operated. The time remaining for warm up of the magnetron appears at the center of the display, counting down from 1:30 to 0:01.

You may press any key at the chart disclaimer screen to show the last-used display, or wait several seconds to let the equipment do it for you.

To turn the unit off, press and hold down the [POWER/BRILL] key until the screen goes dark (approx. 3 sec.). To protect the LCD attach the hard cover. Note that the network sounder will be turned off approx. three minutes after turning off the power.

Note: You are asked if you want to start the simulation mode, which provides simulated operation of the equipment, the first time you turn on the power (or any time power is applied after a memory reset) the message shown below is displayed. Push the [ENTER] knob to start the simulation mode, or press the [CLEAR] key to start normal operation. For further details about the simulation mode, see the paragraph “1.9 Simulation Display.”

START

SIMULATION MODE?

YES ... PUSH ENTER KNOB

NO ... PUSH CLEAR KEY

TO SKIP.

1-7

Page 21
Image 21
Furuno 1753C, 1733C, 1723C, 1762C, 1722C, 1763C, 1732C, 1752C, 1742C manual Turning the Unit On/Off, Startup test