Furuno 1722C, 1753C, 1742, 1752 Erasing an EBL, EBL indication, How to measure bearing with the EBL

2. RADAR OPERATION

EBL1 (Dotted line)

EBL2 (Dashed line)

EBL2 bearing

EBL1 bearing

R:Relative

T:True

.250/	.125nm	° M	EBL
		319.9
SP

H-UP VRM

EBL1

ON

VRM1

ON

OFFSET

EBL2

ON

VRM2

ON

EBL1	EBL2			+359.9° R
VRM1 330.1° R	VRM2	234.1° R
-.---nm			-.---nm	0.24nm

Active marker is highlighted.

How to measure bearing with the EBL

Note: Bearing can be shown Relative to ship’s heading (relative) or in reference to North (True). This setting may be changed by changing the EBL REFERENCE setting, which is in the RADAR DISPLAY SETUP menu. See the paragraph “5.2.1 Radar display setup.”

2.11.3Erasing an EBL, EBL indication

Press appropriate EBL soft key and press the [CLEAR] key. The EBL is erased and its indication becomes blank.

2.11.4Erasing EBL/VRM data boxes

Press the EBL or VRM soft key associated with the EBL/VRM data box you wish to erase. Press the [CLEAR] key once or twice to erase the data box.

2.11.5Hiding EBL/VRM data boxes

Press the ZOOM & D. BOX and D. BOX ON/OFF soft keys to show or hide the EBL/VRM data boxes.

2.11.6Moving EBL/VRM data boxes

When an EBL/VRM data box is obscuring a target that you need to see, you can move it to another location as shown below. This cannot be done when the EBL/VRM soft keys are shown.

1.Press the [EBL/VRM] key to erase the EBL/VRM soft keys if appears.

2.Using the cursor pad, place the cursor inside the data box you wish to move. As the cursor enters the box it changes to a “hand.” Push the [ENTER] knob, and the hand changes to a fist, meaning the data box is correctly selected.

3.Use the cursor pad to drag the data box to the location desired and push the [ENTER] knob.

2-16