Furuno 1762C, 1753C, 1742, 1733C, 1752, 1723C Inserting a Chart Card, Chart card and card remover

1. OPERATIONAL OVERVIEW

1.2Inserting a Chart Card

Your unit reads FURUNO and Nav-Charts™(NAVIONICS), or C-MAP chart cards, depending on its specifications. Insert the appropriate chart card for your area as follows:

1. Open the chart card slot lid.

Chart slot

Display unit

2.Insert desired chart card groove side up.

3.Close the lid to protect the chart drive.

Note 1: Do not insert or remove the chart card while turning power on. This may cause the equipment to freeze.

Note 2: Do not remove a card while the chart is being drawn. This may cause the equipment to freeze.

Note 3: A card remover is supplied to ease removal of chart cards. Attach the card remover to the right-hand side hole on the card and pull to remove card. You can leave the card remover attached to the card while the card is in the card slot - push the card remover leftward until it contacts the recessed area in the card.

Note 4: For multiple display units, do not use the same chart card type in more than one display unit.

Chart card and card remover

1-6