Gemini User’s Manual
Hint | #5: | The eyelet grommet (which signals | Gemini | |||||
|
| to automatically | reverse |
| the | ribbon | ||
|
| direction) should be placed on the ribbon- | ||||||
d |
| spool side of the changeover lever. | ||||||
|
|
|
|
|
|
|
| |
Hint | #6: | Set the other ribbon | spool on the opposite | |||||
|
| spool axle, making sure the “drivepins” are | ||||||
|
| engaged. |
|
|
|
|
| |
Hint | #7: | When | the | ribbon | threading | has been | ||
|
| accomplished, turn the ink ribbon spools | ||||||
|
| by hand, | approximately | four or five | ||||
|
| rotations of the spools. This verifies that | ||||||
|
| everything was done properly and that the | ||||||
|
| ribbon | is smoothly | fed. |
|
|
| |
Hint #8: As shown in Figure
-
-
Used up
Figure 2-19. Turning the ribbon over gives you the same effect as having a new ribbon but at no extra cost.
36
