Graco 332305B important safety instructions Common Error Log entries are listed below

Operation / Data Log

Common Error Log entries are listed below.

Software Fault	An internal software error
	occurred. Contact Graco Cus-
	tomer Service.
Low Level Warning	The unit entered a low level
	warning mode and is running
	low on material. The pump
	continues to dispense material
	for the duration of the low level
	alarm time specified by the
	unit.
Low Level Fault	The alarm time in low level
	warning has elapsed. The unit
	will not pump until the reservoir
	is filled and the fault is cleared.
Cycle 1 Not Detected	In a divider valve system, the
	system has not received the
Cycle 2 Not Detected
	programmed number of divider
Cycle 3 Not Detected
	valve cycles for the specified
	input in the programmed
	backup time.
Pressure 1 Not	In an injector system the sys-
Detected	tem has not received a signal
	from the pressure switch in the
Pressure 2 Not
	designated backup time.
Detected
Pressure 3 Not
Detected
System Already Pres-	In an injector system the pres-
surized 1	sure switch is activated when
	the unit enters a pump on
System Already Pres-
surized 2	mode and may not have
	vented properly.
System Already Pres-
surized 3
Machine Count Sensor	The specified number of
Failure	machine count input activa-
	tions was not received within
	the designated backup time.
Motor Overcurrent	The unit is out of expected
	motor current range. Check the
	system to determine that it is
	functioning correctly (i.e., no
	blocked lines). Continued oper-
	ation at excessive motor cur-
	rents will cause degradation in
	pump life.

High Temperature	Internal temperature of the unit
Warning	is above the designated oper-
	ating. Check the unit and sys-
	tem to determine that it is
	functioning correctly. Operating
	outside of the specified tem-
	perature range may cause
	reduced performance and pos-
	sible unit failure.
Low Temperature	Internal temperature of the unit
Warning	is below the designated operat-
	ing. Check the unit and system
	to determine that it is function-
	ing correctly. Operating outside
	of the specified temperature
	may cause reduced perfor-
	mance and possible unit fail-
	ure.
USB Unable to Mount	The USB flash drive that was
	installed was unable to connect
	and communicate with the
	pump.
USB Unsupported	The USB flash drive is unsup-
Device	ported. Use a different flash
	drive.
USB File Not Found	The pump program setting file
	was not found or created cor-
	rectly. Restore the setting file
	to the flash drive.
USB Folder Navigation	The pump program setting file
	was not found or created cor-
	rectly. Restore the setting file
	to the flash drive.
USB Invalid File	The pump program settings file
	was not found or created cor-
	rectly. Restore the setting file
	to the flash drive.
Failed Pin Code Entry	A failed attempt was made to
	enter the pin code password.

332305B 41