Run Mode
With machine count set, the Rest Cycle (Pump OFF) is ended when the machine count reaches zero (0000).
Machine Count
•A set number of triggered counts.
•The LED next to
•The display indicates the number of machine counts remaining.
The example shown in FIG. 34 shows the remaining number of machine counts is 0045.
HH | MM | SS | ## | ! |
|
|
|
|
ON OFF
MM : SS HH : MM
CP 1
CP 2 | C | 1 2 3 |
CP 3 | P |
|
FIG. 34
Backup Time
In Machine Count mode, if a Backup Time (maximum rest time) has been set:
•The LED next to
•The display shows the amount of time remain- ing till a fault.
The example shown in FIG. 35 shows 4 hours and 17 minutes remaining until a fault occurs.
•If the Machine Count requirements are met the unit will exit the Rest Mode (Pump OFF) and enter the Lubrication Mode (Pump ON).
HH | MM | SS | ## | ! |
|
|
|
|
ON OFF
MM : SS HH : MM
CP 1 |
|
|
CP 2 | C | 1 2 3 |
CP 3 | P |
|
FIG. 35
OFF Time
In Max models if the Machine Count is set to 0000 then Reset Mode (Pump OFF) is controlled with OFF Time (see Time Control, page 51).
54 | 332305B |
