Hobart ML-29044, ML-29191, ML-29048, ML-29188, ML-29039 manual Setting Date & Time on Initial Setup

Quantum Scale System

Setting Date & Time on Initial Setup

QUICK STEPS

From the Start a Run Screen:

1.PRESS [F1]

2.TYPE the Current Date

3.PRESS [ENTER] or [▼]

4.TYPE the Current Time.

5.PRESS [F1] - If Needed

6.PRESS [ESC]

☛Note

There may be a slight delay during Scale Warm-up(depending on room temperature) until the Zero weight appears on the screen. If during Power-up, the Scale Warm- up Box does not disappear from the display screen, contact your local Hobart office for service.

To set the Date and Time the first time you setup the scale:

1.From the Start a Run Screen, PRESS [F1].

2.With the cursor in the Date field, TYPE the current Date. Enter the Date as a six-digit number (MM/DD/YY).

3.PRESS [ENTER] or [DOWN ARROW (▼)] to move the cursor to the Time field.

4.With the cursor in the Time field, TYPE the current Time. Enter the Time as a four-digit number (HH:MM).

5.If you need to change AM or PM, PRESS [F1] to select the correct time of day.

6.When the Date and Time is correct, PRESS [ESC] to save the changes and return to the Start a Run Screen.

☛Note

If designated during Scale Setup, any operator may be permitted to change Date/Time. Refer to Scale Setup in the Supervisor Manual. The Supervisor must change Date/Time if not designated during Scale Setup.

Start-Up Procedures 3 - 4