Quantum Scale System

Communication Connections

Reset Button

In addition to the Power Cord, there are up to four (4) additional ports.

On the left side of the scale, there are several ports for peripherals such as:

Disk Player/Recorder and Cassette Recorder (RS232)

IBM PC Keyboard (Keyboard)

Floppy Disk Drive or Secondary Printer (MODNET)

Future Expansion (i.e., parallel port for Report Printer)

Also located on the left side of the scale is the Reset Button. In the unlikely event the scale stops responding to keyboard input, you will use the Reset Button to reset the scale back to the Start a Run Screen.

To reset the scale, you must:

1.Hold in the Reset Button (small black button) for 2 - 3 seconds. (See Photo above for Reset Button location.)

Note

The POWER key on the front of the Control Panel turns the displays (both operator and customer) ON and OFF. It is only functional from the Start a Run Screen. This key should be used at the end of the day to conserve power.

2 - 3

General Information

Page 13
Image 13
Hobart ML-29035, ML-29191, ML-29048, ML-29044, ML-29188, ML-29039, ML-29037, ML-29032 manual Reset Button