Quantum Scale System
How to Use This Manual
Refer to the following sections for information about using the Quantum Scale System.
♦Chapter Two: General Information provides you basic information about the Quantum’s features including:
*Standard Features
*Communications Connections
*Reset Button
*Control Panel Overview
*Screen Highlights
*Mechanical Procedures
*HELP Key Functions
♦Chapter Three: Start Up Procedures provides you an overview of the
♦Chapter Four: Understanding and Using the Start a Run Screen provides you an overview of the screen, verifying zero weight, identifying, understanding and selecting Weigh and Totals Types, and entering Operator ID’s.
♦Chapter Five: Entering PLU Information describes how to enter PLU data (i.e., through Flashkeys, typing the PLU number or pressing the HELP Key to use the On Screen Library).
♦Chapter Six: Weigh Types details how to perform a transaction within each mode of operation (i.e., Wait on a Customer, PrePackaged Products, etc.)
♦Chapter Seven: Temporary Override of Product Information gives you the details of how to temporarily change product information for a specified Weigh Type.
♦Chapter Eight: Cleaning Instructions gives you procedures for cleaning the exterior of the scale and the printhead.
♦Chapter Nine: Troubleshooting provides you operating tips to assist you with unexpected scale problems.
♦The Appendix provides you additional information on the following:
*Creating Macros (Using the Save/Recall Key)
*Percentage Tare (Proportional Tare)
*Label Types
*Graphics
*Glossary of Commonly Used Terms
♦The Index provides you a listing of the topics in this manual and their corresponding page numbers.
Introduction to This Manual | 1 - 4 |
