Quantum Scale System

Typical On Screen Library Screen

On Screen Library - Auto Look Up

Auto Look Up automatically looks up the product after a set number of digits has been entered. It typically does not require you to press ENTER. The characteristics of Auto Look Up (i.e., On/Off, Number of Digits) are configured during Scale Setup by your Supervisor.

If your Supervisor has selected 4-digit Auto Look Up, then you must PRESS [ENTER] when entering a 1, 2, or 3-digit PLU.

Note

If you need to temporarily change product information, such as tray size or tare, refer to Chapter Seven: Temporary Override of Product Information later in this manual.

Entering PLU Information

5 - 6

Page 52
Image 52
Hobart ML-29039, ML-29191, ML-29048, ML-29044, ML-29188, ML-29035, ML-29037, ML-29032 manual On Screen Library Auto Look Up