Hobart ML-29048, ML-29191, ML-29044, ML-29188 manual Adjusting the Scale Feet, To check scale balance

Quantum Scale System

Adjusting the Scale Feet	There are four (4) Scale Feet located underneath the scale
	system. You may need to adjust these feet slightly in the
	event the scale isn’t sitting on the table/case properly.
	Proper adjustment of these feet, helps you maintain the
	proper scale balance.

To check scale balance:

1.Remove the Scale Platter.

2.Locate the Level on the Scale Sub-Platter. It can be seen through a hole in the scale main housing.

3.Adjust the feet until the “bubble” is in the middle of the level.

To increase the length of the scale feet:

1.Rotate the feet in the counterclockwise direction.

2.Rotate the lock nut until it is firmly against the scale base housing to lock the adjustment into place.

To decrease the length of the scale feet:

1.Rotate the feet in the clockwise direction.

2.Rotate the lock nut until it is firmly against the scale base housing to lock the adjustment into place.

2 - 15 General Information