Operation

Preset View

After you have set the camera presets, you can go directly to the desired views.

1.Press QUAD/SEQ to load the Preset View dialog box.

2.Select the desired preset number to load the preset.

Figure 4-5 Preset View Screen

Digital Zoom Mode

You can enter Digital Zoom mode by pressing the PTZ button on the front panel while in PTZ mode.

Note You cannot enter Digital Zoom mode when the DVR detects video loss on the selected camera or the camera is turned off or set up as Covert 1 or Covert 2.

After you are in Digital Zoom mode, a bright small box is laid over the image. The box indicates the spot to be enlarged. To enlarge the spot, move the position of that box using the Arrow buttons, and then press  . The enlarged screen displays . Pressing PTZ again returns the DVR to Live Monitoring mode.

Recording Video

After you have installed the DVR following the instructions in Chapter 2, Installation, it is ready to record. Unless you change the setup, the DVR continues to record until the hard disk drive is full. The factory default is Stop when the hard disk drive is full. The DVR can be set to continue recording (Overwrite) after the hard disk drive is full. It does this by recording over the oldest video.

Rev 3.03

81

Document 900.0315

 

 

02/07