HP 16555A, 16555D, 16554A manual Introduction

Introduction

The commands in the State Waveform subsystem allow you to configure the display so that you can view state data as waveforms. Up to 96 channels, identified by label name and bit number, can be displayed at a time. The 12 commands in this subsystem are analogous to their counterparts in the Timing Waveform subsystem. In this subsystem the X axis is restricted to representing only samples (states), regardless of whether time tagging is on or off. As a result, the only commands which can be used for scaling are DELay and RANge.

The way to manipulate the X and O markers on the Waveform display is through the State Listing (SLISt) subsystem. Using the marker commands from the SLISt subsystem will affect the markers on the Waveform display.

The commands in the SWAVeform subsystem are:

∙ACCumulate

∙ACQuisition

∙CENter

∙CLRPattern

∙CLRStat

∙DELay

∙INSert

∙MLENgth

∙RANGe

∙REMove

∙TAKenbranch

∙TPOSition

8–2