
Microsoft Network Settings page). If the name is not typed in the web interface, the default name, based on the device's MAC address, is displayed.
The second line of the display shows date, time, IP address, and firmware version in a repeating sequence.
Starting Front Panel Operation
Configure the IP Address for the PSA
Configure the Link Speed and Duplex Mode for the PSA
Set or Change the Front Panel Password
There are three front panel operations: IP configuration, link speed and duplex mode configuration, and password configuration
Use the web interface to further configure the PSA. Refer back to the Getting Started procedures, or refer directly to information about using the web interface to further configure the device.
Configuring the IP Address Using the Front Panel
These procedures explain how to configure an Internet Protocol (IP) address on the PSA using the front panel. (The TCP/ IP and DNS page in the web interface can also be used to do the same.) Configuring the IP address allows the PSA to route print tasks properly.
If the network does not use Dynamic Host Configuration Protocol (DHCP), use the front panel of the PSA to manually enter the IP address, subnet mask, and default gateway.
Configuring the IP Address
Display | Action |
To begin configuring the IP address, press
once.
Press
again.
Select the mode by pressing
or
to toggle between Manual and DHCP.
Press
to continue.